Commercial Fedar DTF Printer Buyer’s Guide: Comparing 13", 24" 5-Head, and 32" 8-Head Production Systems
Updated: 1 hour ago
Choosing a commercial DTF system is a capacity-planning decision, not simply a comparison of print widths. Impact USA is the exclusive US distributor of Fedar and supports B2B quote, demonstration, and sample inquiries across a portfolio of printers, powder shakers, inks, and film. Start with the work you need to produce consistently, then match the printer and finishing line to that work.
Define the production requirement before choosing head count
A wider printer can improve nesting efficiency, while additional printheads can support a higher-output configuration. Neither specification alone tells you how many finished transfers your operation can deliver. Compare your own artwork at an acceptable quality setting and include powder application, curing, cutting, staffing, and maintenance in the evaluation.
Typical artwork dimensions and average gang-sheet utilization.
Daily demand and peak-period demand, including room for growth.
Available floor space and access for media handling and maintenance.
Operator coverage, curing capacity, environmental conditions, and transfer quality standards.
13-inch commercial entry: FDA3 and FD30 PRO
The Fedar FDA3 and FD30 PRO are 13-inch options for a more compact production footprint. They suit an evaluation where space, narrower jobs, and the move into a dedicated DTF workflow matter. Request a demonstration using your real design mix rather than assuming every small-format system has the same production behavior.
24-inch production: FD70-2/4, FD70-5, FD70-6, and Ultra S750
The Fedar FD70 family spans 24-inch configurations from two and four heads through five- and six-head production. The FD70-5 features five Epson i3200-A1 heads. Compare the configuration that meets your usable-output requirement, rather than treating a nominal speed claim as your guaranteed daily throughput.
The 24-inch Ultra S750 gives buyers another printer-and-shaker option in this production-width class. Ask Impact USA to demonstrate the relevant configuration, matched curing workflow, and planned consumables together. The correct choice depends on your jobs, accepted quality mode, production space, and intended workload.
32-inch industrial production: Fedar FD1808
The Fedar FD1808 combines a 32-inch print width with eight printheads for an industrial production workflow. Its appeal is capacity and wider gang-sheet planning, but a purchase evaluation should also consider how quickly your downstream process can handle that output. Bring representative artwork and target volumes to a demo so print production and finishing can be assessed as one line.
Match the printer with an inline powder shaker
Powder coverage and curing are production-critical. Impact USA’s Fedar shaker portfolio includes SH604, SH606, SH808, and SH1308. Select the appropriate system with the printer’s film width and production configuration, rather than choosing it as an afterthought. Ask about curing consistency, powder handling, operating conditions, and the service access your team will need.
Use a demonstration to compare the complete workflow
Run identical artwork through the candidate configurations at a commercially acceptable quality setting.
Evaluate printed detail, white coverage, powder distribution, cure quality, and the final pressed transfer.
Review consumables, operator procedures, maintenance expectations, and installation requirements.
Request a configuration-specific B2B quote and a sample that your team can assess.
DTF ink and film are part of the same decision. Use the consumables you intend to run when establishing your production baseline, and keep results attached to the configuration being quoted.
Talk to Impact USA about the right production system
Request a production quote, print sample, ink/paper sample, or Ontario, CA showroom demo from Impact USA. Call 844-571-8171 or email orders@impact-usa.com. Showroom: 1590 S Milliken Ave, Ontario, CA 91761.
Comments